LDK-20

[ksarb]

Hi all

i am hoping somone can help with this dilema.

i have been given a IP LDK-20 firmware 2.1 analogue

Q1. is LC01/LC02 can i use an RJ11 from a phone socket to these ports?

Q2. Where on earth can i find PCADMIN v2.1 this is so hard to find v3.9 but no 2.1.

please please help

best regards

kevin

 

[abl2910]

Hello

Q1
This port is analog line ports and yes you can use rj11 plug


abl2910

 

[pheex]

I have an ipLDK-20 with the firmware SW66P-B.2Ac Oct/05 and use the LDK PCADMIN software v. 3.9. It appears to work OK. Sometimes you just get the message: "This feature is available from version....

 

[ksarb]

i actually upgraded the system today to GS66P-C9Bc and this worked.

and used 3.9 then to configure it

thanks for the help

best regards
kevin

 

[pheex]

Nice, I have been thinking of updating the firmware but haven't had the time to reed how to. Where did you find the firmware and are there different firmwares for different countries and hardware?

 

[ksarb]

hi

i found it easier than i thought, however remember to backup your database first.
i connected through rs232 and downloaded from the site below:

http://www.artcom.ru/download/?TYPE=6&MODEL=507

does take a while to flash it but all was good, you will need to translate the page but ie8 does it through bing if you click page and translate

Kevin
PS i must admit i always hesitate when i click continue on flashs lol

 

[pheex]

Thanks for the tip. I always hesitate too and I'm not sure I need to update - everything is woking fine right now. I can find two firmware downloads on the page you suggested C9Bc and 3.9Ah. What is the difference?

 

[ksarb]

hi mate c9bc is dated feb 10 i think its the latest

kev

by the way an old IT saying if it aint broken, dont fix it!!

 

[doktor]

Take care when you upgrade... If it goes wrong, often new hardware is need, or you can be lucky that your local dealer can rescue the boards!

///doktor