LD 49 Flexible Code Restriction

[cm6043]

I have some question about the restrick code. This is a partial printout from our M1 Option 11C.
LD 49
:
:
CRNO 5
INIT ALOW
DENY 173
900
00
:
:

Could anyone tell me what the meaning of the above printout.

Thanks !

 

[one234]

Hi,

Everything is allowed
Except: all numbers starting with: 173, 900, 00

The init prompt is the initial restriction:

DENY = Deny all outbound calls
ALLOW = allow all outbound calls

the DENY's and ALLOW's following the INIT are "deeper" restrictions

I.E. an user is allowed to dial all outbound numbers except 0900, but he's allowed to dial 0900-1234, you could make a CRNO with init allow (Everyting is allowed), after that you deny the 0900 range and after that you allow 09001234

Hope this clears it up a bit...


Marc D.

If Bill Gates had a nickel for every time Windows crashed... Oh wait, he does...

 

[bluerigsby]

Further to that the CRNO number i.e. CRNO 5 being the barring table directly relates to the phones NCOS. I say usually as some installer may have associated the numbers differently. But for most cases CRNO 5 means NCOS 5 etc etc

To test your CRNO /NCOS relationship or mapping is straight you should print off your outgoing trunk route data block.

LD 21
REQ : PRT
TYPE: rdb
Cust 0

In the print of you get FRL prompts. as such


FRL 0 0
FRL 1 1
FRL 2 2
FRL 3 3
FRL 4 4
FRL 5 5
FRL 6 6
FRL 7 7

If the mapping like mine is straight then CRNO & NCOS numbers are one & the same.

 

[cm6043]

Thanks everybody

I understand !