Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations Chriss Miller on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
LCOB8 card switch showing Service 2
- Thread starter teomcam
- Start date
-
1
- #2
Service means "temporarily out of order - due to service".
This is done if you park a board in a cabinet, maybe waiting for the second cabinet to arrive...
All active boards should be in the "Normal" position.
You could also park a card in the service position, if the numbers of CO lines are exceeding the limit of a ipLDK system or a cabinet in an ipLDK system.
///doktor
This is done if you park a board in a cabinet, maybe waiting for the second cabinet to arrive...
All active boards should be in the "Normal" position.
You could also park a card in the service position, if the numbers of CO lines are exceeding the limit of a ipLDK system or a cabinet in an ipLDK system.
///doktor
-
1
- #3
That SW is used for selection of short loop loop in some special country. [special country(impedance=600ohm): Standard.India.Israel,China.
Normal position = Short loop
Service position = Long loop
Anyway there are not support the function of Normal/Service selection in ipLDK.
You can specified the loop resistance in PGM155 (Board Attribute)
Normal position = Short loop
Service position = Long loop
Anyway there are not support the function of Normal/Service selection in ipLDK.
You can specified the loop resistance in PGM155 (Board Attribute)
- Status