L3 interface on Cat 3560 PoE 1

[chieftan]

Please excuse my stupidity here, I just cannot seem to work out the problem as shown below:-

I have the following network:-

10.4.4.0 (Vlan4) <---> 3560 <---> 10.4.20.0 (Vlan20)

Also VLAN100 as management.

Basically the setupis as follows:-

2 buildings. Wireless link installed and acts as a bridge to extend one vlan to the other building. The other building has a Cat 3560PoE switch. I need to be able to set up the switch so that the 2 vlan's talk to each other on the same switch.

I have tried various methods and cannot get it to work.

Does anyone have any idea how to set this up, so I can route between the two.

TIA

 

[ADB100]

You have enabled 'IP ROUTING' on the 3560 haven't you?

If this is part of a bigger routed network you need to consider this as well (routing protocols, static routes etc).

HTH

Andy

 

[RookThis]

did you get this to work?

 

[chieftan]

I have this working.

It was the IP Routing command......doh.....

Thanks