Kodak Camera Question DC215

[fidleid]

I have DC215 which worked fine until I installed a bigger memory module. I can see the pictures on the camera but I cannot transfer them to the PC. The transfer starts and then stops. If I put the original module back in the camera works as does the transfer. The new module is the same brand as that which was packaged with the camera. I formatted it in the camera. I need the 460 picture capacity. I am using the software that came with the camera and using W2K OS. I have to stick with W2K as this is a workstation which will not function on this particular LAN if loaded with any other OS.

Thanks in Advance

 

[rjkrash]

Check at the Kodak site for more up to date drivers or firmware for your Camera and Operating System. Post back with success or failure resolving issue(s).
If you found this helpful let us know by voting below.