Join Domain through 2 FVS318'S

[s73880b]

We have a Window's 2k exchange server network set up behind a Netgear FVS318 firewall. We have a remote site set up using W2k Pro also behind a Netgear FVS318 firewall. My question is how do I go about joining our Domain at the remote site? I would also like to join our Domain from home. I also am running W2K pro behind a FVS318 firewall.
the ip address uset for the server network runs like 206.94.181.xx (I do not know why it was set up like this). Our remote site uses 192.168.2.xx. My home is set up with the default 192.168.1.xx. Any suggestion's would be GREATLY appreciated!

 

[ChicagoTechNet]

you should setup site to site vpn. if the firewall is not hardware vpn router, here are the steps. quoted from

http://www.chicagotech.net/

How to Setup A Site-to-Site VPN Connection

To setup a Site-to-Site VPN Connection , you may need to configure two windows servers for the Answering and Calling Routers. Here are the steps:

1. Run RRAS, on Configuration page, select LAN routing.
2. Configure VPN on the Answering Router.
3. Configure the Demand-dial Interface on the Answering Router.
4. Configure VPN on the Calling Router.
5. Configure the Demand-dial Interface on the Calling Router.
6. Confirm the Remote Access Policy Configuration on the Answering and Calling Routers.






Robert Lin, MS-MVP, MCSE & CNE
Windows, Network, Internet, VPN, Routing and How to at

http://www.ChicagoTech.net