I recently converted a branch office 4.5 system over to a MG1000E due to a total system failure of the branch office. Since I converted it the paging trunks don't work now. Not sure what I am missing. The paging trunks are accessed with IP phones, and they were working fine before, but the phones were registered to the branch not the core system.
I have tried COT, WAT and PAG trunks. Nothing works. I can dial the access code and hear dial tone from the DUKANE but as soon as I hit any keys I get dead air. No DTMF tones are being transmitted to the DUKANE. I put a butt set on the trunk and have two way audio when I dial the access code, but again as soon as I hit the first key the audio drops and I can't hear anything coming from the PBX side. I can still hear the dial tone from the DUKANE through my butt set.
Not sure what I am missing. Been a really long time since I worked on one of these old POS systems....
I have tried COT, WAT and PAG trunks. Nothing works. I can dial the access code and hear dial tone from the DUKANE but as soon as I hit any keys I get dead air. No DTMF tones are being transmitted to the DUKANE. I put a butt set on the trunk and have two way audio when I dial the access code, but again as soon as I hit the first key the audio drops and I can't hear anything coming from the PBX side. I can still hear the dial tone from the DUKANE through my butt set.
Not sure what I am missing. Been a really long time since I worked on one of these old POS systems....