I need configure Route ISDN 30B+D with ERICSSON MD110 and IP600 AVAYA. This route is Q-SIG, but only voice calls is ok. The Call-Back and Name Extension is not OK.
I got MD110 with QSIG working with Name & Number, the ACB is implemented differently on both systems. We got it working only one-way once in a test.
We tested with Ericsson techicians.
Let me know which country you're in, I might be able to help Please let me know if the information that was provided is helpfull.
Edwin Plat A.K.A. Europe
The Country is Brazil. Have you Parameters in IP600 and Ericsson MD110? I have experience in Ericsson MD110, the IP600 so so.
I´m sorry for bad english.
here are te settings for the DEFINITY E1 QSIS: PAGE 1
TRUNK GROUP
Group Number: 11 Group Type: isdn CDR Reports: r
Group Name: MD110 QSIG 1 COR: 6 TN: 1 TAC: 808
Direction: two-way Outgoing Display? n Carrier Medium: PRI/BRI
Dial Access? y Busy Threshold: 99 Night Service:
Queue Length: 0
Service Type: tie Auth Code? n TestCall ITC: unre
Far End Test Line No:
TestCall BCC: 4
TRUNK PARAMETERS
Codeset to Send Display: 6 Codeset to Send National IEs: 6
Max Message Size to Send: 260 Charge Advice: none
Supplementary Service Protocol: b Digit Handling (in/out): overlap/enbloc
Digit Treatment: Digits:
Trunk Hunt: cyclical
Digital Loss Group: 13
Calling Number - Delete: Insert: Numbering Format:
Bit Rate: 1200 Synchronization: async Duplex: full
Disconnect Supervision - In? y Out? y
Answer Supervision Timeout: 0
PAGE 2
TRUNK FEATURES
ACA Assignment? n Measured: internal Wideband Support? n
Internal Alert? n Maintenance Tests? y
Data Restriction? n NCA-TSC Trunk Member: 30
Send Name: y Send Calling Number: y
Used for DCS? n Hop Dgt? n
Suppress # Outpulsing? n Numbering Format: private
Outgoing Channel ID Encoding: preferred UUI IE Treatment: service-provider
Replace Restricted Numbers? n
Replace Unavailable Numbers? n
Send Connected Number: y
Send UCID? n
Send Codeset 6/7 LAI IE? n Ds1 Echo Cancellation? n
Path Replacement with Retention? n
Path Replacement Method: better-route
Network (Japan) Needs Connect Before Disconnect? n
PAGE 3
TRUNK GROUP
Administered Members (min/max): 1/60
GROUP MEMBER ASSIGNMENTS Total Administered Members: 60
Port Code Sfx Name Night Sig Grp
1: 01A1401 TN2464 11
Now you need a signaling group aswell:
SIGNALING GROUP
Group Number: 11 Group Type: isdn-pri
Associated Signaling? y Max number of NCA TSC: 30
Primary D-Channel: 01A1416 Max number of CA TSC: 30
Trunk Group for NCA TSC: 11
Trunk Group for Channel Selection: 11
Supplementary Service Protocol: b Network Call Transfer? n
And fially the DS1:
DS1 CIRCUIT PACK
Location: 01A14 Name: Ascom Nira 11
Bit Rate: 2.048 Line Coding: hdb3
Signaling Mode: isdn-pri
Connect: pbx Interface: peer-master
CentreVu Long Timers? n Peer Protocol: Q-SIG
Interworking Message: PROGress Side: a
Interface Companding: alaw CRC? n
Idle Code: 01010100 Channel Numbering: timeslot
DCP/Analog Bearer Capability: 3.1kHz
Slip Detection? n Near-end CSU Type: other
For the Ericsson settings you need to get some help from someone with Ericsson experiance.
Good luck
Please let me know if the information that was provided is helpfull.
Edwin Plat A.K.A. Europe
Send Non-ISDN Trunk Group Name as Connected Name? n
Display Connected Name/Number for ISDN DCS Calls? n
Send ISDN Trunk Group Name on Tandem Calls? n
CPN Replacement for Restricted Calls:
CPN Replacement for Unavailable Calls:
QSIG TSC Extension: 82320
MWI - Number of Digits Per Voice Mail Subscriber: 5
Feature Plus Ext:
National CPN Prefix: 0
International CPN Prefix: 00
Pass Prefixed CPN to ASAI? n
Unknown Numbers Considered Internal for AUDIX? n
USNI Calling Name for Outgoing Calls? n
Path Replacement with Measurements? y
QSIG Path Replacement Extension:
Path Replace While in Queue/Vectoring? n
The QSIG TS extension can be any number you do not use Please let me know if the information that was provided is helpfull.
Edwin Plat A.K.A. Europe
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.