IPX Network Config

[genevolpe]

I am trying to configure an IPX network number under a subinterface. The router <7206> takes the command, but it does not show up in the config. There are plenty of other subinterfaces on the same physical interface that have IP and IPX network numbers config'd on them. What am I doing wrong? Somebody mentioned something about an IPX database, much like the VLAN database on a 2924 CAT?!?!?!?

-TIA
Gene

 

[marsd]

No database per-se as far as I know.
ipx is pretty straightforward..
depending on what you are doing it shouldn't take much more than:
ipx routing

int e0.1
ipx network 2112 encap novell-ether


Debug your config with:
sh ipx route
sh ipx interface
sh ipx traffic
debug ipx routing activity

Good Luck