Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations Wanet Telecoms Ltd on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
IPSI card problem
- Thread starter eyal1975
- Start date
The correct procedure to setup static addressing to an IPSI board would be:
-insert the board
-wait 5 sec
-telnet to the board
-command: ipsilogin
-put login and password
-command: set control interface [ip address] [subnet mask]
-command: quit
-login back in and reset the board
Do not forget the "quit" step or it will not save the settings!!!!!
If you do this and still does not save the settings, replace the board.
Petran.
-insert the board
-wait 5 sec
-telnet to the board
-command: ipsilogin
-put login and password
-command: set control interface [ip address] [subnet mask]
-command: quit
-login back in and reset the board
Do not forget the "quit" step or it will not save the settings!!!!!
If you do this and still does not save the settings, replace the board.
Petran.
- Status
Similar threads
- Question
- Locked
- Question