IPO500 with Loud Ringer

[ThePhoneGURU]

Hello,
IPO500 v2 unit 8.0 Basic System with combo card (2 analog ports)
one analog port 331 is used for paging out to paging amp. Which has been configured ok
The other analog port 332 is to be used for Loud Ringer(3rd party ringer wired also into paging amp)
Just stuck on the setup for loud ringer.
Would like loud ringer to go off when incoming trunks ring.
I've tested my loud ringer by dialing extension 332 so I know it works through paging amp.
Just need to marry incoming trunks to this analog port.
Can anyone offer some feedback to this IPO newbie?

 

[intrigrant]

does it have to ring phones too?
set a incoming call route for this trunk and set 332 as the destination > only the bell rings users can answer the call by dialling *30
create a collective group with the extensions which must ring on a call include the extension 332
route the incoming call to the group

A simple mind delivers great solutions

 

[ThePhoneGURU]

Hello Thanks,
Heading to site now,
yes all phones need to ring too

 

[1043]

Create Hunt Group put all phones and extention 332 in it. Route all calls to the Hunt Group.

 

[1043]

sorry missed the basic part.