Ipldk300 UK

[eats4treats]

Guys

Triple cab ipldk300 with a PRI card in each cab. Why, every so often, would the PRI in the top(3rd)cab disappear in programming? I have to re-do pgm 101 and 103 to get working again.

Ive swapped the PRIB card for a new one. Don't believe i'm over porting it or time slotting it!

I'd say once a week this happens.

On site friday pm if anyone wants to drop some ideas prior to tomorrow.

Cheers

Eats

 

[montyzummer]

what firm ware are you on ?? if you go into brandy can you see the board when it has gone in programming??

APSS (SME)
ACSS (SME)
ACIS (UC)

 

[eats4treats]

Monty

I believe the Prib has the correct revision ie. 3.0gd i think. Its the correct version for sure. I dont use brandy to check its gone, I connect via IPLDK Admin and where clicking for board assignment it isnt listed in the top cab!. As imple 1 min program and NO reset cures it.

I have swapped the PRIB out of the main cab around and it still does the same thing(No issues on the PRIB in main cab). Could clocking be an issue?

Eats

 

[SteveBUK]

Hi Eats - I would check that each on the cabs has the ISDN Clocking cables connected. Each ISDN in the cabs will clock back to the LMU in the cab.
Also to double check the ports and time slots - what's in each cab?
Regards
Steve

 

[doktor]

If the system wasn't properly initialized in the beginning (start) by PGM450 and 452, I have seen this earlier.

///doktor

 

[eats4treats]

Steve

Thank you for your assistance today. Much appreciated.

Eats