ipLDK-20 programming help req

[SolvingIT]

Hi, I have a ipLDK-20 system. The battery on the MB had a dry connection, the battery pack had a blown fuse and whoever installed it did a really bad half job! I put a new battery on the mb, also had to replace a bridge rectifier on the board and put a new battery pack in. the phone system is now in its default settings. Can anyone assist me to connect pc admin and help by programming the system remotely. PLEASE. its a small office... 1 switchboard phone, extensions. or just assist me step by step on my requirements

thanks

 

[doktor]

You can contact me - after reading the details shown at this link below.

///doktor
____________________________________

http://www.kandu.dk/spg153996.aspx

 

[doktor]

You may find many good hints, manuals and s/w here:

http://www.comunicat.com/lg-ericsson/area-tecnica/

///doktor
____________________________________

http://www.kandu.dk/spg153996.aspx

 

[doktor]

Or better:

http://www.comunicat.com/lg-ericsson/area-tecnica/software-ipldk.php

///doktor
____________________________________

http://www.kandu.dk/spg153996.aspx

 

[rsatech]

Hi,
First you need to set your Nation Code. See procedure below:

PROCEDURE FOR PRE-PROGRAMMING
(1) Set DIP switch 8 as ‘ON’
(2) Set Nationality, and reset the system (PGM 450–FLEX 15). Then slot
assignment is configured.
(3) Set DIP switch 8 as ‘OFF’ to retain current configuration.
(4) Set Rack Slot Assignments (If configuration is not equal to the system default slot assignments,
you must program it manually.
(5) Set Logical Slot Assignment. (After Logical Slot assignment or Rack Slot assignment, the system
must be reset manually.
(6) Set Numbering Plan Type.
(7) Set Flexible Numbering Plan.

If you don't have your Nation Code, let me know where your from and I will post it