iPECS TNET problem 1

[kiway]

We are installing 2xiPECS 100 and 1xiPECS 300 systems and are trying to get TNET working (transparent networking)we have the correct licenses have done cmds 330 -333 and have the correct IP adresses of systems and routers but can not ring between sites. Does any one know the correct proceedure or other commands to implement this, would be very much appreciated.

 

[abl2910]

Hello
On the CM system you have data for only LM, no programming in prg 331
On the LM system you have only data for CM, no programming in prg 332

you count total ports ex. 35 inc. voice and conference if in use, 15 ports on CM and 10 ports on LM1 and 10 ports on LM2

The CM system have data (prg 332) for ports LM1 10 ports, LM2 10 ports

The LM system have data for CM reg.(prg 331) of LM1 10 ports, LM2 10 ports

And the modules have T-NET on in prg 132 board base


Abl2910

 

[abl2910]

Hello
sorry
this one
The LM system have data for CM reg.(prg 331) of LM1 10 ports, LM2 10 ports

sould be
The LM1 system have data for CM reg.(prg 331) of LM1 10 ports

The LM2 system have data for CM reg.(prg 331) of LM2 10 ports