IP VOICE CONNECT to CISCO - ONE-WAY HEARING PROBLEM

[dimas]

Hi Great All,
I have R11 with installed CLAN and MEDPro boards.
The forms ch node-names, data-module Ethernet, ip-codec,
Ip-interfaces, signaling/trunk groups and ip-network-region are filled.
The problem is I can dial number from Definity to Cisco (via ARS) and I can hear ring-back tones but I can not hear the answer. Called party subscriber is hearing me good.
I hear only silence and busy after the other side hung up.
We had change the codec but it was no difference (G.711, G.729). I believe somebody had this problem too, please prompt me a way…
Thanks
Dimas

 

[BuckWeet]

What kind of cisco device??


CallManger or IOS gateways? what?

 

[dimas]

Thank you for responce.
Our partner uses CISCO 3660.
IOS type (no CallManager).

( There is a config from Cisco, I am sorry for
off-topic for the Forum)
interface FastEthernet0/0.3
description ### Voip Net ###
encapsulation dot1Q 3
ip address X.X.X.X 255.255.255.192
h323-gateway voip interface
h323-gateway voip id CLAN ipaddr X.X.X.166 1720
h323-gateway voip h323-id testCALL
h323-gateway voip bind srcaddr X.X.X.X

dial-peer voice 102 voip
destination-pattern [0-9]T
session target ras )

 

[BuckWeet]

Try making a voip dialpeer that points back to that Definity.. I've had it sometimes where there is one way voice, just because there is not VoIP dialpeer defined. So pretty much the Cisco box doesn't know how to talk, codec wise and such...


BuckWeet