Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations Chriss Miller on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

IP trunk woes...

Status
Not open for further replies.

lever

Technical User
Aug 17, 2001
259
GB
Hi all,

I have serched this site and read as much as possible from the docs, but I cannot find the answer to this problem.
I have set up IP trunks between two S8710's and everything looks ok.
I can dial the TAC then the number but i don't see the call getting out.

0011/001 T00091 in-service/idle no
0011/002 T00092 in-service/idle no
0011/003 T00093 in-service/idle no
0011/004 T00094 in-service/active no

sig group
Group Number: 11 Group Type: h.323
Remote Office? n Max number of NCA TSC: 4
SBS? n Max number of CA TSC: 4
IP Video? n Trunk Group for NCA TSC:
Trunk Group for Channel Selection: 11
Supplementary Service Protocol: a Network Call Transfer? n
T303 Timer(sec): 10

Near-end Node Name: MainClan1 Far-end Node Name: Clan2
Near-end Listen Port: 1720 Far-end Listen Port: 1720
Far-end Network Region: 1
LRQ Required? n Calls Share IP Signaling Connection? y
RRQ Required? n
Bypass If IP Threshold Exceeded? n
H.235 Annex H Required? n
DTMF over IP: out-of-band Direct IP-IP Audio Connections? y
IP Audio Hairpinning? n
Interworking Message: PROGress
DCP/Analog Bearer Capability: 3.1kHz

If i do a list trace from my phone and i put it in the aar table i get this....
16:56:56 active station 8900 cid 0x1f3a
16:56:56 dial 2649 route:UDP|AAR
16:56:56 term trunk-group 11 cid 0x1f3a
16:56:56 dial 2649 route:UDP|AAR
16:56:56 route-pattern 100 preference 1 cid 0x1f3a
16:56:56 seize trunk-group 11 member 1 cid 0x1f3a
16:56:56 Calling Number & Name NO-CPNumber blain, H
16:57:06 denial event 1220: Recovery on timer expiry D1=0xaf D2=0x66
16:57:06 idle trunk-group 11 member 1 cid 0x1f3a
16:57:08 idle station 8900 cid 0x1f3a



can anyone please?

lever

 
Is 2649 administered in the UDP table?
How many digits are you inserting?
Is the entry in the AAR table?
Does Route Pattern 100 delete the unnecessary digits?

Kevin
 
oh yea it's in there alright. I have 4 digit dialing set up going over the normal trunks, but i set this one stn up just to test the IP trunking.

Even before i did the aar stuff, just trying the TAC then some one's number still didn't get through unless i did a normal ISDN TAC/number

Thanks Kevin.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top