I am getting ready to upgrade from a 1601 to a 2620 XM. On the 1601 I had ip host-routing enabled (this was set up long before I got here). I see this is no longer a command. What was it? On the 2620XM it has no ip routing in the config. Not sure if I need to enable ip routing or not. Our network is as follows:
T1-->CSU/DSU-->Router-->FW Appliance-->Switch-->LAN
I'm thinking I don't actually need the ip routing since the appliance is the only thing actually connected to the router from the inside.
Also, what does no ftp-server write-enable do?
T1-->CSU/DSU-->Router-->FW Appliance-->Switch-->LAN
I'm thinking I don't actually need the ip routing since the appliance is the only thing actually connected to the router from the inside.
Also, what does no ftp-server write-enable do?
