ip configuration

[Midiean]

What is the command line instruction for dropping old static ip address, subnet, gateway, and DNS server addresses and applying new addresses to each?

I've seen this done before, switching between two different routers on the same line, but that was about a year ago.

Thanks

 

[bcastner]

For DHCP obtained IPs:
ipconfig /release
ipconfig /renew

For command line access to static IP settings, use NETSH.EXE

http://support.microsoft.com/defaul...port/kb/articles/Q242/4/68.ASP&NoWebContent=1

 

[TonyT26]

DHCP or Static?
For static IP's you'll need to go into the TCP/IP properties for the adaptor you're using to make those changes. ncpa.cpl from the command line will get you the area you need to be, in W2K/XP. If it's DHCP, as long as your network is pushing an IP, just reboot or ipconfig /[release/renew], your choice.


-T