No matter what I do I keep getting this error message provided below.
Can anyone help or seen this error message before?
It is for a CISCO 1924 Switch.
Diagnostic Console - Systems Engineering
Operation firmware version: 0.00.00 Status: invalid
Boot firmware version: 3.02
WARNING!!! Operation firmware is invalid.
Upgrade firmware to enable switch operation.
Upgrade operation firmware (XMODEM)
System debug interface
Enter Selection: U
The XMODEM protocol will be used to perform this firmware upgrade.
The user must initiate an XMODEM file transfer from the terminal
side using an appropriate terminal application specific command.
Do you wish to continue with the download process, [Y]es or [N]o? Yes
Erasing invalid flash - may take up to 1 minute.
Erasure completed.
Do you wish to upgrade at [9]600 (console speed) or [5]7600?
Can anyone help or seen this error message before?
It is for a CISCO 1924 Switch.
Diagnostic Console - Systems Engineering
Operation firmware version: 0.00.00 Status: invalid
Boot firmware version: 3.02
WARNING!!! Operation firmware is invalid.
Upgrade firmware to enable switch operation.
Upgrade operation firmware (XMODEM)
Enter Selection: U
The XMODEM protocol will be used to perform this firmware upgrade.
The user must initiate an XMODEM file transfer from the terminal
side using an appropriate terminal application specific command.
Do you wish to continue with the download process, [Y]es or [N]o? Yes
Erasing invalid flash - may take up to 1 minute.
Erasure completed.
Do you wish to upgrade at [9]600 (console speed) or [5]7600?