Intuity Audix port question.

[ScoTTeL]

Okay, I am going to sound dumb here. I have never worked with Intuity before. When looking at the back of a tower MAP100, which port is port 1? Is it the top most card or the bottom one. I have 2, 6 port cards in this system.

Also, if I hook up all analog ports and place them in a hunt will the system work? Or do I need a C-Lan connection or some other data connect to fully integrate?

ScoTTeL Office Solutions
PBX, Fiber Optic, Cabling and Networking Installation and Service. See me on Sundance Communications Installers Link Page

 

[phoneguy55]

I forget but an easy way to find out is to plug an anlog extension into one then log into the audix and goto voice system administration, then to system monitor. You will see each port there. You should be able to figure it out from there when you call the extension. You will also need this screen to make sure every port is answering.

Use the Clan. You going to need this info for your install. Good luck.

http://support.avaya.com/japple/css...a&temp.productID=107682&temp.releaseID=133352

 

[donbott]

I think the bottom right is the first one.

DonBott

 

[lopes1211]

bottom is board 1. MODE CODE integration will allow you to just use the analog stations for integration without the need for CLAN or DCIU.

-CL

 

[pconelli]

Would anymore know if you can set up a broadcasting on an intuity audix?