InterVLAN Routing on a switch

[robman70]

Is there any router config required for layer 3 routing with a cisco 3550 switch? i followed the procedures from

http://www.cisco.com/en/US/tech/tk389/tk815/technologies_configuration_example09186a008019e74e.shtml

and am able to route between VLANs on the switch, but i cant ping the next hop router


Internet
^
|
r1 s1 192.168.1.100
|
| <----point to point t1
|
r2 s0 192.168.1.101
r2 f0 172.16.20.35
|
|
3550 f0 172.16.20.36
|
/ \
/ \
/ \
vlan2 vlan3
10.6.1.2 10.6.2.2

i cant ping 192.168.1.101 from vlan3...is there any configuration required that isnt listed on the page i referenced?

 

[vipergg]

As indicated over in the cisco forun where you posted you need to use static routes on each side or implement a routing protocol like ospf or eigrp.