Thanks crazynoodle! I tried this and I can't get the break sequence to work. The prompt also should be "Boot#" if I'm not mistaken. I get this
TinyROM version 1.4(1)
19:37 11/07/00
Copyright (c) 1998-2000 by cisco Systems, Inc.
All rights reserved.
POST ............ OK. 4MB DRAM, 8MB Flash.
Configured boot failed, attempting fallback boot.
Booting "c800-y6-mw.121-6.bin" ...,
Restricted Rights Legend
Use, duplication, or disclosure by the Government is
subject to restrictions as set forth in subparagraph
(c) of the Commercial Computer Software - Restricted
Rights clause at FAR sec. 52.227-19 and subparagraph
(c) (1) (ii) of the Rights in Technical Data and Computer
Software clause at DFARS sec. 252.227-7013.
cisco Systems, Inc.
170 West Tasman Drive
San Jose, California 95134-1706
Cisco Internetwork Operating System Software
IOS (tm) C800 Software (C800-Y6-MW), Version 12.1(6), RELEASE SOFTWARE (fc1)
Copyright (c) 1986-2000 by cisco Systems, Inc.
Compiled Wed 27-Dec-00 16:48 by kellythw
Image text-base: 0x000EA000, data-base: 0x00615000
Cisco C803 (MPC850) processor (revision 1) with 43360K bytes of virtual memory.
Processor board ID JAD0532045U
CPU part number 0x2101
Bridging software.
Basic Rate ISDN software, Version 1.1.
2 POTS Ports
1 Ethernet/IEEE 802.3 interface(s)
1 ISDN Basic Rate interface(s)
4M bytes of physical memory (DRAM)
8K bytes of non-volatile configuration memory
8M bytes of flash on board (4M from flash card)
Press RETURN to get started!
00:00:21: %LINK-3-UPDOWN: Interface Ethernet0, changed state to up
00:00:22: %LINEPROTO-5-UPDOWN: Line protocol on Interface Ethernet0, changed sta
te to up
00:00:24: %LINEPROTO-5-UPDOWN: Line protocol on Interface BRI0:1, changed state
to down
00:00:24: %LINEPROTO-5-UPDOWN: Line protocol on Interface BRI0:2, changed state
to down
00:00:27: %SYS-5-CONFIG_I: Configured from memory by console
00:00:27: %SYS-5-RESTART: System restarted --
Cisco Internetwork Operating System Software
IOS (tm) C800 Software (C800-Y6-MW), Version 12.1(6), RELEASE SOFTWARE (fc1)
Copyright (c) 1986-2000 by cisco Systems, Inc.
Compiled Wed 27-Dec-00 16:48 by kellythw
00:00:27: %LINK-3-UPDOWN: Interface BRI0, changed state to up
Router>
Is the software on this router not fully IOS compliant. I also can't seem to access the web page giving other 'possible key combinations for break sequence during password recovery'. I'm stuck! Thanks for your help so far, much appreciated!
