Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations Chriss Miller on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Interface Overrun

Status
Not open for further replies.

heyhey88

MIS
Joined
Mar 28, 2002
Messages
1
Location
US
I'm seeing some overruns on my FastEthernet Interface. Should I be concerned about these? What causes and Overrun?

The FE is connected to a HP Procurve 4000M Full Duplex.



FastEthernet1 is up, line protocol is up
Hardware is DEC21140, address is 0010.7b47.4eca (bia 0010.7b47.4eca)
Internet address is 172.19.100.254/16
MTU 1500 bytes, BW 100000 Kbit, DLY 100 usec, rely 255/255, load 3/255
Encapsulation ARPA, loopback not set, keepalive set (10 sec)
Full-duplex, 100Mb/s, 100BaseTX/FX
ARP type: ARPA, ARP Timeout 04:00:00
Last input 00:00:00, output 00:00:00, output hang never
Last clearing of "show interface" counters 18:35:05
Queueing strategy: fifo
Output queue 0/40, 0 drops; input queue 0/75, 0 drops
5 minute input rate 808000 bits/sec, 257 packets/sec
5 minute output rate 1414000 bits/sec, 231 packets/sec
33366365 packets input, 1841376769 bytes, 0 no buffer
Received 178418 broadcasts, 0 runts, 0 giants, 0 throttles
0 input errors, 0 CRC, 0 frame, 76692 overrun, 0 ignored, 0 abort
0 watchdog, 0 multicast
0 input packets with dribble condition detected
37755711 packets output, 3710257238 bytes, 0 underruns
0 output errors, 0 collisions, 0 interface resets
0 babbles, 0 late collision, 0 deferred
0 lost carrier, 0 no carrier
0 output buffer failures, 0 output buffers swapped out
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top