Installing a Wake up call card

[elwormo]

I have a nortel networks meridian system. This system is used in a hotel. I just took over for a IT systems manager who left. This card was down and on order when I took over. Can anyone tell me how to install the card. I was told by a semi reliable source that you just remove it and slide in the new card. It is mounted in a cabinet "super loop shelf". I just wanted to verify this info.

The part # for the card is nt5g15AA
Manual says X11 release 25
thats all the info I have as of now, hopefully this is enough.

Thanks in advance,
Brian

 

[johnpoole]

i would do a stat on the card in load 32 stat x x x.. with the tn of the card, then disc x x x, should see a red light, when the card software disable's.. then do the hardware swap and still in ld 32 enlc x x x.. the light should go green....

john poole
bellsouth business
columbia,sc

 

[elwormo]

Load 32 will not take. i can get in load 20. I can stat the card and it shows disb next to the top 7 lines. I installed the new card changing over drive in slot A. Thn did a enlc on 52 0 0. it seems to take but then I still have a red light just under mivs at the top.
Any suggestions. I also have a backup small pcmcia drive and tried it.

Thanks,
Brian

 

[PERRYPJ]

SOUNDS LIKE THEY DIDN'T GIVE YOU LEVEL 2 PASSWORD WHICH YOU WILL NEED TO GET INTO LD 32

OLD ROLMEN WORKING ON NORTELS

 

[johnpoole]

ld 20 ...try ench x x on the channel and see if they come up. load 32 can be added to level 1 password at the pass data, but you'll have to get someone with level 2 to adjust the access...if the command takes and comes back without a sch your command seems like it's going

john poole
bellsouth business
columbia,sc