Installing a medpro on a G3Rv11

[dsldefinity]

We are looking to install a TN2302AP Medpro on an older Definity G3Rv11. Does anyone have any good links to Avaya Documentation that would give me the step by step instructions?
Thanks

 

[4merAvaya]

'change node-name ip' and add the IP address and name for the board.

'change ip-interface' and add the board and gateway information.

Kevin

 

[dsldefinity]

I did these two steps above and I can ping the medpro. When I launch IP softphone I get the call control from my PC and can ring an extension, but I do not set up the voice path. The PC headset and mic are set up correctly. The c-lan and medpro are both in network region 1. What am I missing in the medpro config?

 

[phoneguy55]

what codec are your set up for and what bandwidth setting on your softphone?

G.711 = LAN
G.729 = dsl/cable

 

[dsldefinity]

Soft phone set up as "LAN" the switch is running G711 for network region 1 where the devices are located.