imaging exits with error 209 ?!?

[hellbeach]

Hello
I have finished one workstation which I´m going to take an image of and then distribute to a bunch of other computers but I run into problem during the image-taking. Just as the image-taking is about to finish I get an error on the screen which says:
--
ZENworks imaging failed with error:209
/dev/hda1 -- ZEN partition
/dev/hda2 -- Active partition
Re-installing the boot code
Added imaging *
Added prompt
Added activepartition
INIT: switching to runlevel: 6
INIT: Sending processes the TERM signal
--

After this the workstation reboots and boots the linux partition again and starts taking the image again, and the same thing happens over and over...

I have been searching novells homepage for a while but not found the "error:209" for ZENworks, does anyone know what the hickup might be ?

/Dan

 

[hellbeach]

I found the solution to this very annoying problem:
´The imaging hung on some specific files located in winnt\profiles\***
After removing these files from certain profiles the imaging went fine.

Does anyone know why this problem occurs ?