ILMI fails on 7010/RSP w/ SNMP-3-BADOID: Error

[nelsonherron]

I have gotten a little further than the last time with my ATM/SNMP-3-BADOID: error. It seems that this error is generated when ILMI attempts to start on my 7010/RSP7000 running 12.2.7 IOS equipped with a CX-AIP-SM 155 MM card (73-1188-03 rev B0). The card works properly in a 7007 w/ RP1 running 11.2.15 from ROM, and the cisco site indicates that any board later than 73-1188-02 rev. D0 will work with the RSP7000. When ILMI is enabled, it's state is listed as "Restarting" and I get the SNMP-3-BADOID: about once a second when the cable is connected to a switch. I've also tried IOS 12.1.soemthing or another to no effect. If I disable ILMI the card appears to work fine.

 

[nelsonherron]

THe issue turned out to be a bad bus termination at the RSP7000 chassis interface. A new CI cured the problem. Had to buy a new router, too, but it only cost about the same as the shipping. Scary how much UPS makes off eBay.