technodrew
Technical User
best way to clean up all cross connects (riser involved)
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations derfloh on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
if moving cables and doing a MOV in the system >
- Thread starter technodrew
- Start date
- Status
LD 20, LUVU type TNB. Go to each TN and left the crossconnect and snip off the very end so it is smooth.
Tug a little and pull them off pair by pair.
Pull too fast and you will burn insulation off of the in-use cross connect.
Silicone spray - pure - no petroleum sprays - if you have super dense areas or corners to turn.
Tug a little and pull them off pair by pair.
Pull too fast and you will burn insulation off of the in-use cross connect.
Silicone spray - pure - no petroleum sprays - if you have super dense areas or corners to turn.
- Status
Similar threads
- Locked
- Question
- Locked
- Question
