Hunt BRI Issue 2

[joxers25]

I cannot Hunt my BRI's to each other.
I have followed the advice on here from previous tread thread798-1226728 but this functionality is still not working for me.

This is the config I have:
_______________
REQ iss


VERSION 2111
RELEASE 22
ISSUE 46 +
_________________

_________________
>ld 27

BRI000
MEM AVAIL: (U/P): 302878 USED: 303329 TOT: 606207
DISK RECS AVAIL: 385
BRI DSL AVAIL: 92 USED: 8 TOT: 100
LTID AVAIL: 100 USED: 0 TOT: 100
TNS AVAIL: 530 USED: 470 TOT: 1000
REQ prt

TYPE dsl

DSL 30 0

DATE

PAGE

DES

NACT



TN 30 0 0 0
DES RFAX
CUST 0
CTYP SILC
OPT BRIL
MISP 6
MODE NTAS
B1CT VCE DTA
B2CT VCE DTA
LDN NO
XLST 0
MTEI 8
MCAL 16
MTSP 8
LAPD 1
PRID 2
PDCA 3
FDN 6059
EFD 6059
HUNT 6059
EHT 6059
TGAR 0
NCOS 0
SGRP 0
CAC 3
CLS UNR ICDD CDMD MRD UDI ABDD DNAA PGND
DATE 16 MAY 2007
______________________

Any help again appreciated.

 

[johnpoole]

it's programed right.. but i seem to remember that i had that problem back when 22 was new and it took a patch. that said, if your vendor still supports your switch then they need to install that patch.. you have done your part

john poole
bellsouth business
columbia,sc

 

[StanleySteamer]

Also in LD 27 you need to print the TSP for 30 0. That is where you allow hunting.

 

[joxers25]

Cheers guys - john for confirming that it was all good and stan for the TSP

HTD was set in TSP

Thanks Again