How to setup a Option11 C with 2 PRI card using 1 CC and 2 DCH

[RevelinoSuriname]

Is there something special that you need to program to have a second PRI card working on a Option 11C. The Second PRI have a DCH, but does not have a CC.

The CC is on the First PRI Card. The First PRI Card is running as a Slave to a Master Clock at another side (PBX A).

How can i have the right settings for the second PRI to have that connected to a New Side (PBX C).

summary:

PBX B:
one PRI with CC and DCH working as slave to PBX A
One PRI with DCH (tries to wok with PBX C)

PBX C:
one PRI with CC and DCH working in FRUN (should be slave to PBX B?)

PBX B and PBX C are connected Point to Point via a Fiber Connection. I'm using a Versitron Fiber Multiplexor (E1) FYI;

Thanks in advcance
Cheers!

Revelino

 

[johnpoole]

that does not require any change to the ddb, your pref is already set to the card with the cc.. your secondary is free-run i assume... your telling the cc on that card to track off of the far end. all t's clock from the active cc.. all we change is where the cc looks for sync.. just build the d, add the card to the cequ.. then, ld 16 ld 14.. ld 96 to enable the dch and the tmdi and serv (if needed) ld 60 to bring it up..

john poole
bellsouth business
columbia,sc