HOW TO RESTRICT CHANNELS FROM OUTBOUND DIALING

[huntsville]

hOW CAN I RESTRICT 28 CHANNELS FOR INBOUND, LEAVING ONLY 2 FOR OUTBOUND. ON THIS DID PRI LINE.

DES PRIDID
TN 019 06
TYPE DID
CDEN SD
CUST 0
TRK PRI2
PDCA 1
PCML A
NCOS 0
RTMB 19 6
B-CHANNEL SIGNALING
NITE
AST NO
IAPG 0
CLS UNR DTN WTA LPR APN THFD
P10 VNL
TKID
DTCR NO
DATE 30 NOV 2005

 

[johnpoole]

set it up in two routes

john poole
bellsouth business
columbia,sc

 

[srmega41]

Good call. One thing to be careful of is how the Search is set up from the CO. If it is round robin, two routes could create an issue for outbound calls, since the CO only sees one route but the PBX would take incoming calls on two.

I would agree with John and go a step further and see if you can get a linear (if it is not already) search set up for your PRI. Then make your new route the last two members of the incoming route search pattern from the CO.

Scott M.

 

[johnpoole]

the outbound two trunks would be 22 and 23 in most cases.. those are usually the last two inbound and the 1st two outbound. but scott is right, need to make sure.. stat that pri and do some ld 81 trad's you'll see where the co is sending. way eaiser then trying to get them on the phone..

john poole
bellsouth business
columbia,sc

 

[worldwidedialtone]

On E1 service outside US the first channel then in linear order is usually incoming from CO so Channel 29 and 30 in a differenet route like John said is the way to go then in your RDBs set for ICT or OGT as needed instead of IAO for ICOG

 

[huntsville]

thanks.

i was looking at any option in the trunk level itself we can control, rather than in route, but No.

 

[hawks]

You can do at the Route level like everyone said it's a pretty quick set up.