Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations derfloh on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
How to reset/enable MSDL and TMDI card?
- Thread starter RedRookie
- Start date
Firebird Scrambler
Systems Engineer
I tend to do the MSDL commands in LD 96, although it's also done in LD 48.
Best to do e.g. STAT MSDL first to list them all out.
Typical commands are DIS MSDL xx to disable it.
ENL MSDL xx to enable it or ENL MSDL xx FDL to run the self tests.
RST MSDL xx to reset the card without having to reseat it on site.
All the best
Firebird Scrambler
Meridian 1 / Succession and BCM / Norstar Programmer in the UK
If it's working, then leave it alone!.
Best to do e.g. STAT MSDL first to list them all out.
Typical commands are DIS MSDL xx to disable it.
ENL MSDL xx to enable it or ENL MSDL xx FDL to run the self tests.
RST MSDL xx to reset the card without having to reseat it on site.
All the best
Firebird Scrambler
Meridian 1 / Succession and BCM / Norstar Programmer in the UK
If it's working, then leave it alone!.
For TMDI cards, the commands in LD 96 are similar:
STAT TMDI
DIS TMDI l s c to disable
RST TMDI l s c to reset a card
ENL TMDI l s c to enable card
ENL TMDI l s c FDL to enable and force a software download to the card (need to do this anytime you make a change in card programming, such as changing from DTI to PRI, DCH-type changes, etc.
STAT TMDI
DIS TMDI l s c to disable
RST TMDI l s c to reset a card
ENL TMDI l s c to enable card
ENL TMDI l s c FDL to enable and force a software download to the card (need to do this anytime you make a change in card programming, such as changing from DTI to PRI, DCH-type changes, etc.
- Status