I NEED TO PASS THE CONFIGURATION PAGE ON CISCO 802 ROUTER IN ORDER TO ACCES MY NETWORK FROM ANYWHERE. THE PROBLEM IS THAT WHEN I ACCESS MY IP ON THE INTERNET I COULD NOT PASS THE CONFIGURATION PAGE. IT ASK ME FOR USER NAME AND PASSWORD BUT ONLY LET ME CHANGE THE CONFIGURATION. PLEASE IF ANYONE KNOW HOW TO ENABLE THE PORT 80 OR OTHER TRICK LET ME KNOW...THANK YOU
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations Chriss Miller on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
HOW TO PASS THE CONFIGURATION SCREEN
- Thread starter JUAN325
- Start date
The way I understand your setup - you have an ISDN box, that gets 1 public IP from your ISP. Your network behind it is using private IP range. You want to access one of your systems from outside.
To achieve this, you need to configure your router to use PAT - port/address translation. Take a read here:
BTW, if you just want to telnet into one of your boxes, you can just telnet into router, and then telnet into a system on internal net from there.
Good luck.
To achieve this, you need to configure your router to use PAT - port/address translation. Take a read here:
BTW, if you just want to telnet into one of your boxes, you can just telnet into router, and then telnet into a system on internal net from there.
Good luck.
- Status
Similar threads
- Locked
- Helpful tip
- Locked
- Question
