I have a subreport that only applies to about half of my records so when I print I get lots of blank pages (the subreport is the entire 1st page)that I dont need. Is there any way to either make blank pages not print or make the subreport not show if there is no data?
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations bkrike on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
How to make a subreport not show if there is no data for it? 1
- Thread starter Blitz
- Start date
-
1
- #2
I just finished a Main report with 10 sub reports where any or all of the sub reports could show up. I had some blank areas until on the main report for each sub report, set the properties to both "can shrink" and "can grow". While on the main report I did this for each sub report and now I don't have any blank areas. Another place to look is the "keep together" property which I set to "no". <br><br>Hope this helps.<br>Jerry
- Status
Similar threads
- Locked
- Question
- Locked
- Question
- Locked
- Question
- Locked
- Question