It's done in LD 117.
The info below is uded to cancel any alarms.
From Rlse 22 it is possible to filter out unwanted alarms, especially those that are not service affecting such as NWS 202 messgaes when the system tests MMail Loops during the midnight routines. Modify in LD 117 as follows:-
LD 117 c/r
PRT EPT ALL c/r
If the above comes back empty, you need to place the following alarm codes in there, as follows:-
NEW EPT CIOD107 INFO c/r
NEW EPT CIOD157 INFO c/r
NEW EPT NWS401 INFO c/r
NEW EPT NWS301 INFO c/r
NEW EPT EDD010 INFO c/r
Then check by doing PRT EPT ALL again. This has the affect of making the error codes in this table for "Information only".
Install any that are causing nuisance alarms that are not service affecting.
All the above will bring up a minor alarm unless they are place in the EPT table. If a code is down as minor, in the EDT table it will NOT generate a minor alarm, Only alarms flagged as MAJOR or CRITICAL will flag up a MN on the console. The EDT cannot but altered, but the system will check the EPT table if prog`d to see if a code appears there.
All the best
Firebird Scrambler
Meridian 1 / Succession and BCM / Norstar Programmer in the UK
If it's working, then leave it alone!.