How much DLOP can I have in a single physical Card 1

[canopus]

I have a DLOP configured as TRK in my card 004 0 04.

Can I configure a second DLOP as PRI in the same card as 004 1 04?

Help ASAP with this please

 

[KCFLHRC]

NO

 

[KCFLHRC]

You will have to put a TMDI card in 4 1 4

 

[canopus]

Ok I understand. To enable the PRI DLOP I have to delete the TRK DLOP first. Can you show me how I can do it without Delete the DLOP in 004 0 03?

I have in ld 22:

>ld 22
PT2000

REQ prt
TYPE cequ

CEQU
MPED 8D
TERM
REMO
TERD
REMD
TERQ
REMQ
SUPL V004 V060 V080 V156
V252
SUPC
SUPF
DDCS MG_CARD
DTCS
XCT 000 016
CONF *001 *017
MGTDS IPMG IPMG_TYPE
200 004 0 MGC
205 004 1 MGC
MGCONF IPMG PORTS IPMG_TYPE
201 004 0 30 MGC
202 004 0 30 MGC
206 004 1 30 MGC
207 004 1 30 MGC
MFSD * 000 * 016 * 200 * 205

DLOP NUM DCH FRM TMDI LCMT YALM T1TE TRSH MG_CARD
TRK 100 24 D4 YES AMI DG2 0 00 004 0 03
101 24 D4 YES AMI DG2 0 00 004 0 04
APVL
DTI2 MG_CARD
MISP MG_CARD
SYNM 0
EXT0 3PE
EXT1 3PE
MCFN 011 MB

I just want to change it to PRI DLOPs

 

[canopus]

I forgot to mention that I´m integration an Asterisk via PRI ESS5 D4 AMI to CS1000 Nortel.

 

[KCFLHRC]

To change it from TRK to PRI you have to delete everything and rebuild it.

 

[canopus]

When I want to Delete the TRK DLOP, it gives an error. Do I have to delete some configuration first to delete the TRK DLOP?

 

[KCFLHRC]

You have to out the trunks in ld 14, then out the route in ld 16, then possibly delete the clock reference in ld 73 and then it will allow you to remove the DLOP

 

[canopus]

CAN YOU SHOW ME THE COMMANDS? I have tryied a lot of times without success.

 

[KCFLHRC]

This is a very involved process. I suggest you contact your vendor and have them do the work for you.

 

[canopus]

Thanks.