As is often the case, it MIGHT happen in a UNIQUE case and scenario, a LOT of people use the MOVE and CPY commands with no issues, but there were cases where it did cause problems in the past, and the best explanation was that MOVE commands within their own SUPERLOOP / LOOP should be OK, but MOVEing a set from 1 superloop to another might cause problems......
(but not confirmed by NORTEL)
I have not experienced it on LARGE systems but I have run into it on OPT11c running 23.xx software, What happened in my case is when I moved a TN to another location that part worked fine, but whe ORIGINAL TN the phone was moved from a "UNMODIFIABLE" M2317 appeared with nothing for the keys or settings, you could not out it and it caused AUD error on the PBX. Quick fix was to reboot the PBX and it outed the set on boot up....
NORTEL = NEVER SAY NEVER I guess.....
__________________________________________________________
Find a job you love and you'll never work a day in your life. - Confucius