Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations Chriss Miller on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
how do you recover data from a broken hard drive?
- Thread starter honeypot
- Start date
Put the drive in another system as slave, then copy everything over.
That is providing the drive is recognized in BIOS, and will spin up.
If not, you'll have to pay for a recovery service to get your data. Cheers,
Jim
reboot@pcmech.com
Moderator at Staff at Windows 9x/ME instructor.
Jim's Modems:
That is providing the drive is recognized in BIOS, and will spin up.
If not, you'll have to pay for a recovery service to get your data. Cheers,
Jim
reboot@pcmech.com
Moderator at Staff at Windows 9x/ME instructor.
Jim's Modems:
ShaithisDanoveur
MIS
Be forewarned, recovery services are expensive, starting at around $1 per megabyte plus clean room time and breakdown.
I agree with what they posted, slap it in another system and copy it over. Once you have done that to the best of your ability, see the reply I left to the thread "BAD SECTORS" and they will ad you more. You can also use software that will read and read and read and read the same sector over until it THINKS it knows what the data there is. I've been able to recover data many times that was thought to be hopeless.
If you can't get any other data off it you could turn to good old American ingenuity and smack the drive while it's trying to access the damaged area, but only if the HDD heads are plinking. This jars them enough that they can sometimes read the data. I don't recommend that, but if the drive is bad anyway?!?!
Scott
If you can't get any other data off it you could turn to good old American ingenuity and smack the drive while it's trying to access the damaged area, but only if the HDD heads are plinking. This jars them enough that they can sometimes read the data. I don't recommend that, but if the drive is bad anyway?!?!
Scott
Where is the i/o data error coming. If during boot you can write new system info on it that may allow it to run
Or booting from a floppy may allow access to it.
You could try pulling it out of the system and changing orientation while it is running. this was particularly effective on older drives.
Because it is a i/o error it indicates that it has partially, or fully, booted, so the slave drive approach is a good idea. But make note of where the problem is before hand so you'll know what to suspect when you get your data transferred.
Ed Fair
efair@atlnet.com
Any advice I give is my best judgement based on my interpretation of the facts you supply.
Help increase my knowledge by providing some feedback, good or bad, on any advice I have given.
Or booting from a floppy may allow access to it.
You could try pulling it out of the system and changing orientation while it is running. this was particularly effective on older drives.
Because it is a i/o error it indicates that it has partially, or fully, booted, so the slave drive approach is a good idea. But make note of where the problem is before hand so you'll know what to suspect when you get your data transferred.
Ed Fair
efair@atlnet.com
Any advice I give is my best judgement based on my interpretation of the facts you supply.
Help increase my knowledge by providing some feedback, good or bad, on any advice I have given.
- Status
Similar threads