Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations Chriss Miller on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

How do I get DTR and CTS enabled ?

Status
Not open for further replies.
maxcrook

maxcrook

Programmer
Joined
Jan 25, 2001
Messages
210
Location
GB
Im trying to set up a cisco 2500 the same way that another of our routers is set up - however i cant get the modem hardware states show as CTS and DSR - they are showing as noCTS and noDTR (as below) does anyone know how to enable them? sorry for all the stupid questions.


Capabilities: Hardware Flowcontrol In, Hardware Flowcontrol Out Modem CTS-Required
Modem state: Idle
Modem hardware state: noCTS noDSR DTR RTS
 
Status
Not open for further replies.

Similar threads

CPM86
  • Locked
  • Question Question
Cisco isr 4331 with IOS and sip busy fail over to 2nd sip number on pbx?
Replies
0
Views
560
CPM86
CPM86
jobsp90
  • Locked
  • Question Question
I have a issue in my office hospital network regarding using IPPBX software.
Replies
2
Views
528
DavetheChef
DavetheChef
Skip Rango
  • Locked
  • Question Question
how to backup cisco sg500-52p switch
Replies
1
Views
798
madwok
madwok
WinstonCH
  • Locked
  • Helpful tip Helpful tip
What is wrong with the diagram, there are people who will help to fix it? How do i do the configurat
Replies
1
Views
897
BIS
BIS
Lccarter
  • Locked
  • Question Question
Cisco CUCM Provisioning and Order Management System
Replies
1
Views
464
Lccarter
Lccarter

Part and Inventory Search

Sponsor

Back
Top