How do I change a queueing strategy

[psbucs]

Can somebody please explain how I can change the current queueing strategy from fifo to weighted fair ?

Virtual-Access1 is up, line protocol is up
Hardware is Virtual Access interface
MTU 1500 bytes, BW 56 Kbit, DLY 100000 usec,
reliability 255/255, txload 13/255, rxload 209/255
Encapsulation PPP, LCP Open
Listen: CDPCP
Open: IPCP
PPPoE vaccess, cloned from Dialer1
Vaccess status 0x44, loopback not set
Interface is bound to Di1 (Encapsulation PPP)
Last input 00:00:01, output never, output hang never
Last clearing of "show interface" counters 3w0d
Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: 0
Queueing strategy: fifo

Thanks ....

 

[psbucs]

guess not ...

Thanks

 

[chieftan999]

Well, you have to look at the way Interfaces interpret and pass on the packets.
Normally an Ethernet or FA interface on a router will be set as FIFO (First in First out) because the speed of the link is good enough to handle this.
A serial link is different though, so it is normally run as Weighted fair.
I think Cisco put it this way with defaults....anything about 1.54 mbps can be FiFo and anything below is normally Weighted fair.

To configure an Interface to be Weighted fair have a look at the following Cisco link and it will tell you.

http://www.cisco.com/univercd/cc/td/doc/product/software/ios120/12cgcr/qos_c/qcpart2/qcwfq.htm

Reamin positive. The affect on those around you will amaze.

 

[psbucs]

thanks for the link chieftan999 ...