conquer2006
Technical User
How do I assign an IP address on E2T card using Putty, or any other procedure? Please very urgent.
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations Chriss Miller on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
How do I assign an IP address on E2
- Thread starter conquer2006
- Start date
- Status
use console raw to port 2007
set inet on ethernet to IP for 2nd cpu
set host to ip of existing main controller
set gateway
user = ftp
ftp password @
set flag to 0x00 ( 0x40 = DHCP)
should reboot twice then do tftp from existing
If I never did anything I'd never done before , I'd never do anything.....
set inet on ethernet to IP for 2nd cpu
set host to ip of existing main controller
set gateway
user = ftp
ftp password @
set flag to 0x00 ( 0x40 = DHCP)
should reboot twice then do tftp from existing
If I never did anything I'd never done before , I'd never do anything.....
- Status
Similar threads
- Locked
- Question
- Locked
- Question
- Question