How can I remove data extension?

[slengua]

I'm trying to remove data extension 2017 which used to be a data mod for our old R300 remote office system. The system keeps saying "Must disable associated link before removing data module". I gotta say I'm stumped. I can't find this link anywhere. Here is the current programming on the extension.

remove data-module 2017 Page 1 of 1
DATA MODULE

Data Extension: 2017 Name: R300 Bike Patrol
Type: ethernet
Port: 03B1117
Link: 5




Network uses 1's for Broadcast Addresses? y


Anyone know what the heck the system is talking about?I want this extension gone!! We have an S8700 CM 2.1

 

[TykeUK]

Use the command "list usage extension 2017". This will show you what the data module is currently assigned to.

 

[slengua]

I tried that first and got nothing. Which is why I posted this.

 

[mikeydidit]

This has changed a bit since the G3R days. On the R it was ch ip-ser (I believe) and there you could disable the link to remove it or just change the IP address. Now it is "ch ip-inter and the port number". That will let you disable it to remove.

"You don't stop playing because you get old. You get old because you stopped playing."

 

[h5n1]

do a 'li con bo 3b11' see if this is a clan, or val card. then do a 'ch ip-int 3b11' and put a 'n' in the enable ethernet port section, then remove the data module.

 

[sjforcum]

You can tell it's a CLAN based on the fact it's using port 17....