HIPCOM SIP LINES

[MMWTEK]

I have a job coming up later this week on an ip office v2 8.0 where the customer is moving
from gamma to hipcom. I have been chasing hipcom for the required credentials and have also been
asking what the routers ip address will be so I can setup an ip route in the same manner as the
current gamma sip ipdc setup. Keep getting knowhere when asking these ques.

I got the sip trunking 4.2 rev manual from them and will follow this to the letter. Noticed in the
manual it mentions uk.dc.sipconnect.hipcom.co.uk ( direct vpn access BYON )
and uk.icsipconnect.hipcom.co.uk ( all other products ) and gives the following proxy addresses
85.119.61.4 and 85.119.63.4 . This is the first hipcom site I have done so just looking for any
pointers on how its normaly set up to the ip office. They have provided me with the username and
password for the main sip number and info ( see below ) that just seems to relate to the leased line . Would it
be the uk.dc.sipconnect if its getting presented on a leased line. From this info I have been given
do you reckon they are expecting me to connect the phone system direct to the leased line presentation
and have the ip office using a public ip address. Any advice would be appreciated .

Info -

The leased line details are:
[A] WAN IP = 212.67.xx.xx
WAN subnet mask = 255.255.255.252
[C] Default Gateway = 212.67.111.xx
Routed IP's network number = 212.67.112.xx
[D] Routed IP mask = 255.255.255.252
[E] First host = 212.67.112.xx [F] Second host = n/a Last host = 212.67.112.xx
DNS servers 195.74.130.12 and 195.74.128.6

Test SIP Trunk = 441270756528
username: 441270756xxx@company.com
Password: 1234567
Avaya IP Office PBX
Call Capacity 1

Main SIP Trunk = 441224658xxx
Username: 441224658xxx@company.com
Password: 1234567
Avaya IP Office PBX
SIP DDI’s: = 01224650xxx – 01224650xxx
Call Capacity = 14 Calls



M

 

[Gunnaro]

First, I'd get a new public IP, you just told everyone where to look.
Second, never ever do a direct connect, it's not safe!

Kind regards

Gunnar
__________________________________________________________________
Hippos have bad eyesight, but considering their weight, it’s hardly their problem

 

[hairlessupportmonkey]

Took me ten seconds to find this dev connect note

Hipcom on rel 8

ACSS - SME
General Geek

 

[amriddle01]

We use Hipcom trunks, dead easy, just username and password then set registration timer to 60, use uk.ic.sipconnect.co.uk, no proxy required and that's it. No port forwarding is required at all unlike Gamma, so just leave it behind NAT as you would a PC

 

[amriddle01]

Sorry missed the .hipcom.co.uk after the sipconnect above