High call rate

[trond345]

Hi All,
I have a solidus ecare4.1SP2 connected to MD110 BC12sp7, where i have two digital dialoic boards at the solidus side (60)channels connected by ISDN Q-sig to the MD110 for one of the of the GSM operators. I have the ALARM HIGH CALL RATE (CLASS1)? did any one face this before and how to be solved.

How could I increars the number of calls /second in order to overcome this problem.


CLASS: 1
320 HIGH CALL RATE
DATE TIME ALP NOIF UNIT EQU INF1 INF2
04Feb06 09:24:57 1 255 RMP 001-*-**-** 0 24
THE SYSTEM IS ONE LIM SYSTEM,,,TWO MAG. (2 TMU,2NIU).

MD110 is connected to the GSM switch by 2E1-PRI(60 channels)

I resrted this program unit (RMP) but he same.

Is there any advice

 

[HIREI]

Hi,
as it seems to me, the problem was discussed earlier (patch and so on), use Search function.

 

[trond345]

THANKS, I know that this alarm is generated when The average call rate has exceeded the threshold of 12 new calls every 10 seconds. Normal call rate is less than 9 calls per 10 seconds. but is there anyway to increase that threshold., in order to override this alarm.

 

[HIREI]

For example:

http://www.tek-tips.com/viewthread.cfm?qid=1048840

Golden words :
"You have to much traffic the limit in BC9
(if I remember) is 0.9 calls per second.
According to your alarm its over 2 calls
per second. Try figure out "who" is making
all calls. If it's normal you have to add
more lims and spreed the trunks and extension
between them."

 

[IPuser]

Or an Upgrade, to BC12, would give you up to 2 calls/second (per LIM).