Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations wOOdy-Soft on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Help opening ports
- Thread starter tschafer
- Start date
Do you want to Nat this to a specific device or do you just want the router to just allow the traffic.
If you wantto NAT, just use the ip nat command like so:
ip nat inside source static tcp 192.168.2.196 25 23.104.19 25 extendable
if you just want to allow traffic Create an Access Class and put it into the WAN side of the interface.
If you wantto NAT, just use the ip nat command like so:
ip nat inside source static tcp 192.168.2.196 25 23.104.19 25 extendable
if you just want to allow traffic Create an Access Class and put it into the WAN side of the interface.
- Status
Similar threads
- Locked
- Helpful tip
- Locked
- Question