1way2findout
Technical User
I have a hipath 4000, but the analog stations are not sending tones or pulse when a keypress is done. I have a ring genarator card Q2468 and the SLMA card Q2246.
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations SkipVought on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Help no tones on analog staion keypress/Hipath 4000 ?
- Thread starter 1way2findout
- Start date
- Status
Some older analog sets care about polarity. SO first try switching tip and ring.
If that does not help, check the loop current through the set with the set off hook. If it is less than 23 milliamaps then that could be your problem. In that case you may need to use aa station card that supports long wire runs, or there may be a configuration options such as 24 verus 48 volts.
Let us know what you find.
Good luck
If that does not help, check the loop current through the set with the set off hook. If it is less than 23 milliamaps then that could be your problem. In that case you may need to use aa station card that supports long wire runs, or there may be a configuration options such as 24 verus 48 volts.
Let us know what you find.
Good luck
- Thread starter
- #3
1way2findout
Technical User
You are a life saver, worked great with switching tip ring.
- Status
