Help needed configure cisco 3600 serial interface

[nootgevallen]

Hi ,

Someone that can help me how to configure serial 2/1 or 2/2 ??

My cisco 3600 router (192.168.1.1) lost his serial configuration.
I don't now how to configure serial 2/1 and 2/2

serial 2/2 must look like this in my routing table

192.168.4.0/24 is variably subnetted, 2 subnets,2masks
R 192.168.4.1/32 is directly connected serial 2/2
C 192.168.4.0/24 [120/1] via 192.168.4.1,00:00:22. serial 2/2

serial 2/1 must look like this in my routing table

192.168.3.0/24 is variably subnetted, 2 subnets,2 masks
C 192.168.3.1/32 is directcly connected ,serial 2/1
R 192.168.3.0/24 [120/1] via 192.168.3.1,00:00:22. serial 2/1

When i do show interface serial 2/1 or 2/2
i get serial 2/2 or 2/1 is up but line protocol is down.

running-config shows for serial 2/2 or 2/1 :

!
interface Serial2/1
ip unnumbered Ethernet0/0
encapsulation ppp
no ip mroute-cache
ipx helper-address -1.ffff.ffff.ffff
ipx network 1000300
ipx type-20-propagation
compress stac

thanx for helping.!!1

 

[ROUTERKID1]

Are you talking about a sub interface for the serial connection ? int s0.1

 

[nootgevallen]

I've already found it ,

I reset the Router that didn't work .
I reset the Leased lines (serial).

But there was another powercable that is used to power the connection of the leased lines and receiving and moving the data to the interfaces.

We had a Storm here in Holland , with lighting so said the Leased line company.

I reset that and BINGO My router table comes back and the connection to my other sites .

Thanx for help ....