help , iam a newbe

[spivy66]

I am very new to the cisco world but I have a problem maybe some one can help. I have one of my cisco 2600's setup and i config the interface but iam getting a Duplex mismactch discovered on ethernet 0/0( not full duplex), with another on my network-- router Fast Ethernet). I did my research and says that i should be in full duplex mode( need to be in the same mode as other router ,but Idon;t know how to set it in full duplext mode. I could not find the right command. please help

 

[fdurham]

spivy66-

All you have to do is get into the interface and type i the following commands.

1. router>ena
2. router#conf t
3. router(config)#int fastethernet 0/0
4. router(config-if)#duplex full

duplex full is the command.

That should do it.
Frank

 

[spivy66]

Yes that did it. Thank you. I am trying to get a understanding on this 2600. it just seems like there so much. Is there a good place to start? ( website) anyways thank you for your time

 

[PalmTest]

Cisco switches:

http://www.cisco.com/en/US/products/hw/switches/tsd_products_support_category_home.html

Cisco security and VPN:

http://www.cisco.com/en/US/products/hw/vpndevc/tsd_products_support_category_home.html

Cisco 2600:

http://www.cisco.com/en/US/products/hw/routers/ps259/tsd_products_support_series_home.html