Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations derfloh on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
HBA
- Thread starter gatetec
- Start date
I think you will have to access the SAN switch and you will get plenty of commands showing the above data. Just access it and issue the help command. I don't remember a specific command for now coz it has been along time since i logged in to the switch.
Good Luck
Regards,
Khalid
Good Luck
Regards,
Khalid
RMGBELGIUM
MIS
it all depends on what brand of switches you have, as each switch has it own syntax ( mcdata is other then brocade )
for a switch config of brocade :
SupportShow -> shows full config of switch
portcfgShow -> will show portspeeds,autonegotiate,...
or just type help on the prompt to see an overview of all commands available
rgds,
R.
for a switch config of brocade :
SupportShow -> shows full config of switch
portcfgShow -> will show portspeeds,autonegotiate,...
or just type help on the prompt to see an overview of all commands available
rgds,
R.
- Status