Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations bkrike on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Hardware requirements for line failover, load balancing?

Status
Not open for further replies.
Speaker

Speaker

MIS
Sep 5, 2001
72
US
We currently have a 1600 router for Internet connectivity.

If we wish to provide load balancing and especially an alternative failover route for traffic, should our primary carrier go down, what would we need to upgrade to?

I'm assuming a 2600 or so, but would we need any special modules or IOS versions to accomplish this?

Thanks
 
Status
Not open for further replies.

Similar threads

jarod_paris
  • Locked
  • Question
firmware for an AP2800 WiFi terminal
Replies
0
Views
442
jarod_paris
jarod_paris
woza
  • Locked
  • Question
GNS3: Delete the lines "transport preferred none"
Replies
1
Views
525
DrB0b
DrB0b
B
  • Locked
  • Question
Cisco IP phone 7841 8851 unable to forward all to external number
Replies
0
Views
227
badwolf1686
B
telemarksman
  • Locked
  • Question
ATA Cisco SPA122 not triggering single line courtesy phone ringer
Replies
0
Views
251
telemarksman
telemarksman
disk-us
  • Locked
  • Question
RTU licensing for a901
Replies
0
Views
207
disk-us
disk-us

Part and Inventory Search

Sponsor

Back
Top